Hardware Configuration of the Master

At a Glance

The CANopen bus is managed by a Premium PLC in which a TSX CPP 110 card has been installed and configured.

For more information on the TSX CPP 110 card, please refer to the hardware chapter of this document.

Mounting Procedure

The following table describes the procedure for physically installing a TSX CPP 110 card.

Step	Action
1	Check that the PLC power supply is switched off.
2	Install and secure the modules of the base rack.
3	Insert the TSX CPP 110 card into its slot on the processor.
4	Wire the PLC power supply and switch the power on. Note: Once the PLC's power supply has been correctly connected, the software can now be configured.