This chapter describes how to use the Control Expert Device Editor to configure remote device properties, including properties that define:
-
the connection between the remote device and the communication module
-
the degree to which the actual remote device must match the remote device described in the Control Expert project configuration
-
other settings required by the remote device manufacturer that are unique to the remote device
NOTE:
-
-
Before you can configure settings for a device, the device DTM must be disconnected from the remote device itself. If necessary, you can disconnect a DTM by selecting its node in the DTM Browser then selecting Edit → Disconnect.
-
The DTM for a device determines its configuration template. The topics presented in this chapter described configuration settings that apply to devices manufactured by Schneider Electric and to non-manufacturer-specific generic devices.
This chapter contains the following topics:
