Parameter Adjustment
(Original Document)
Preliminary Operations
Before beginning parameter adjustment, you must first backup the project on the hard drive and transfer it to the PLC.
Adjustment Procedure
The following operations must be performed to adjust the parameters:
Step
Action
1
Set the PLC to RUN.
2
Open the configuration editor for bus X from the project browser.
3
Double click on the module which needs adjusting. Position 3 of Rack 1 can also be selected and the Edit → Open module command executed.
4
Activate the View → Adjustment command to access the parameters adjustment screen:
5
Enter the new parameter values for channel 0:
  • Target window = 320 micron
  • Speed (manual mode) = 5400 mm/min
  • PO value = 0 micron
6
Confirm the entries with the Edit → Confirm command or click on the icon
7
Select channel 1 in the channel zone then select the new values for this channel:
  • Offset encoder = 8388607
  • Following error 1 and 2 = 8000 micron
  • Target window = 8000 micron
  • Speed (manual mode) = 5400 mm/min
8
Confirm the entries with the Edit → Confirm command or click on the icon
9
Save the new values in the PLC processor, using the Services → Save parameters command.