The Sequence control parameter is used to define the action to be taken when movement without stop (G01, G11 ou G30) is not followed by a movement command.
If the sequence control is enabled (default value):
-
G01, G11 and G30 movements not followed by a movement command are stopped (equivalent to a STOP command) and a command refusal is generated.
In this case, the movements without stop cannot be sequenced by synchronization on the DONE bit.
-
G01, G11 and G30 movements followed by G05, G07 or G62 movements are stopped if this second command is not itself followed by a movement command.
Disabled Sequence Control
If sequence control is disabled, G01, G11 and G30 movements not followed by a movement command continue at their target speed.
