How to assign and then configure a reflex function

At a Glance

By default, the output channels of a reflex module are classified as standard discrete outputs. It is therefore necessary to reassign the chosen function for each channel used.

Configuring a reflex function involves defining its operating conditions such as :

the sequential logic associated with the various inputs,
the type of output chosen,
the parameter-setting of the block.

The sequential logic is created with ladder language using the language objects associated with the reflex module concerned.

Procedure

The following table shows the various steps for configuring a reflex function block.

Step	Action
1	Access the module configuration screen.
2	Select the Config. outputs tab.
3	Click in the Functions cell of the channel to be assigned.
4	From the drop-down list, select the chosen function.
5	Carry out the sequential logic. To do this, click in the chosen cell, then : select a graphic object (contract, link, input set to 1), for a contact, select : the variable (%Ixy, %Qxy, ERR), the address i. select the coil type.
6	Confirm the configuration.