At a Glance
This function allows you to modify the state of all or part of the channels of a module.
NOTE: The state of a forced output is frozen
and can only be modified by the application after unforcing. However,
in the event of a detected error leading to output fallback, the state
of these outputs -assumes the value defined when configuring the Fallback mode parameter.
The various commands available are:
for one or more channels:
force to 1
force to 0
unforcing (when the channel or channels selected are forced)
for all the channels on the module (when at least one channel is forced):
global unforcing of channels
Procedure
The following table shows the procedure for forcing or unforcing all or part of the channels of a module.
Step |
Action for one channel |
Action for all channels |
|---|---|---|
1 |
Access the module's debugging screen. |
|
2 |
In the Value column, right-click the cell of the required channel. |
Click on the Global unforcing button found in the general parameters field. |
3 |
Select the required function:
|
|