Results of the PL7 application conversion
(Original Document)
About us
Introduction
The results of the conversion of a PL7 application into a Control Expert application are described in the following paragraphs.
Results
At the end of the conversion procedure, there are two possible scenarios:
If the application has been correctly converted, it is displayed on screen and may be saved in Control Expert application format (.stu file).
In the event of conversion errors, you must manually correct the application in order for it to be exploitable. The output window, which can be used to manually correct these errors, is automatically displayed on the screen.
NOTE: the converted PL7 application may be saved in Control Expert application format (.stu) even if conversion errors have not been corrected. If this is the case, the next time the application is opened, you must first launch an Analysis of the application, in order to display the output window on the screen.
NOTE: conversion errors appear in the report but not concerning errors not related to the program (e.g. an incomplete configuration in the FEF) are listed in a section located at the start of the master task.