End of the analysis procedure

Introduction

The procedure of analyzing a PL7 application or a PL7 converted into Control Expert ends when the output window is displayed on the screen.

End of analysis

Once the analysis procedure is over, there are 2 possible scenarios:

the output window contains CONVERROR messages: in order for the converted application or DFB to be exploitable, you must manually correct these conversion errors and delete the corrected CONVERROR messages before saving,
the output window does not contain CONVERROR messages: the converted application or DFB is directly exploitable for compilation and transfer to the PLC.

NOTE: At any time during the manual correction of the converted PL7 application or PL7 DFB, you must delete the corrected CONVERROR messages and save the application in Control Expert format (.stu file). If this is the case, the next time the application is opened, you must first launch an Analysis of the application, in order to display the output window on the screen.