DNP3 Client Configuration Web Page

Access the Page

Access the DNP3 Client Configuration web page through the SETUP tab for the BMENOR2200H module (SETUP > MENU > RTU PROTOCOL CONFIGURATION > DNP3 Client Configuration).

Parameters

Find these parameters and settings on the on the DNP3 Client Configuration web page:

Parameter	Description
Channel Name	This is the name of the selected channel.
Enable TLS	Select (check) this box to enable TLS.
Enable TLS	Deselect (uncheck) this box to disable TLS.
Secure Authentication	SAv2
	SAv5
	Disabled
Enable Aggressive Mode	Select (check) this box to enable aggressive mode.
Enable Aggressive Mode	Deselect (uncheck) this box to disable aggressive.
Current User	Click the Select button to open the Current User dialog box to define the active user. NOTE: You can click the Key Management link in the Current User dialog box to go directly to the DNP3 Key Management web page.
Advanced Settings	Click the Configure button to open the Advanced Settings dialog box and configure these parameters: GENERAL AUTHENTICATION PARAMETERS SAV2/SAV5 PARAMETERS NOTE: There are several parameters in the Advanced Settings dialog box. Click the information icon (i) to the right of any parameter field to see a description of the acceptable values.
Submit	Click this button to apply the modifications to the selected channel.
Add Channel	Click this button to open the Add Channel dialog box on which you can create an additional channel using the above-listed parameters. Click the OK button to add an entry to the table (with the new User Name).

Limitations

NOTICE

UNINTENDED EQUIPMENT OPERATION

Use different address values for each session in a channel or for each section in a session.
Use successive DB mapping starting at 0 in the DNP3 protocol.
Do not configure the DNP3 client to control a point that is not configured in the DNP3 server point mapping.

Failure to follow these instructions can result in equipment damage.

The BMENOR2200H module does not support multiple RTU protocol instances.

Execute Changes

After you configure any of these parameters, press the Apply button in the page banner to implement your changes.

NOTE: The Apply and Discard buttons are disabled (grayed out) when the configuration is not valid.