DNP3 Server Configuration Web Page

Access the Page

Access the DNP3 Client Configuration web page through the SETUP tab for theBMENOR2200H module (SETUP > MENU > RTU PROTOCOL CONFIGURATION > DNP3 Server Configuration).

Parameters

Find these parameters and settings on the on the DNP3 Server Configuration web page:

Parameter	Description
Channel Name	This is the name of the selected channel.
Enable TLS	Select (check) this box to enable TLS.
Enable TLS	Deselect (uncheck) this box to disable TLS.
Secure Authentication	SAv2
	SAv5
	Disabled
MAC Algorithm (HMAC)	Select the MAC algorithm to be applied in challenges.
Key/Account tTable	This table lists these client/server options: User Number User Name User Role (operator, viewer, single user) Key Wrap: Select AES-128 or AES-256. Key: Enter the key wrap algorithm (hexadecimal format). Apply: Click this button to record your modifications.
Enable Aggressive Mode	Select (check) this box to enable aggressive mode.
Enable Aggressive Mode	Deselect (uncheck) this box to disable aggressive.
Current User	Click the Select button to select a user role: viewer operator NOTE: No user can change the role of another user. For more information on role permissions, refer to the description of RBAC.
Advanced Settings	Click the Configure button to access these advanced parameters for the selected channel: GERNERAL AUTHENTICATION PARAMETERS SAV2/SAV5 PARAMETERS NOTE: Click any information icon (i) to see a description of the corresponding parameter.
Submit	Click this button to apply the modifications to the selected channel.
Add Channel	Click this button to create a channel with this configuration.

Limitations

NOTICE

UNINTENDED EQUIPMENT OPERATION

Use different address values for each session in a channel or for each section in a session.
Use successive DB mapping starting at 0 in the DNP3 protocol.
Do not configure the DNP3 client to control a point that is not configured in the DNP3 server point mapping.

Failure to follow these instructions can result in equipment damage.

The BMENOR2200H module does not support multiple RTU protocol instances.

Execute Changes

After you configure any of these parameters, press the Apply button in the page banner to implement your changes.

NOTE: The Apply and Discard buttons are disabled (grayed out) when the configuration is not valid.