Introduction to the TBX ESP 08C22 Module
(Original Document)
About us
General
The TBX ESP 08C22 sealed (IP65) remote output module is a monobloc module comprising 8  24 VDC, 0.5 A static outputs.
It is equipped with M12-type connectors for direct wiring of the pre‐actuators.
The outputs are protected against overloads and short-circuits.
When there is a fault at an output, the I/O indicator lamp lights and the output is set to state 0. To reactivate it, this output must be reset once the fault has been rectified.
The preactuator voltage is monitored to ensure consistent processing of the outputs during variations in the power supply.
Technical Specifications
The following table provides the technical specifications of the module.
TBX ESP 08C22
Nominal voltage
24 VDC
Supply voltage
19.2 to 30 VDC
Current drawn at +24 V (1)
107 mA typically at 24 V
Current drawn at +24 V (2)
(with no active outputs)
120 mA typically at 24 V
Power dissipated in the module
(loading = 60 % of active outputs)
4.1 W at 24 V
Dielectric strength between outputs and ground (GND)
1500 VDC for 1 min
Isolation resistance
> 10 MΩ below 500 VDC
Protection against a reverse polarity on +24 V (1)
Yes: diodes in series (3)
R on outputs
1006 Ω max
Key:
(1)
Power supply to module (communication and output interfaces).
(2)
Power supply to preactuators.
(3)
Only when the module 24V and the pre-actuator 24V are isolated.