Introduction
Configure the SERVICE port for the 140CRP31200 module on the Control Expert Service Port tab.
Access the Service Port Tab
Step |
Action |
|---|---|
1 |
In Control Expert, access the module for Online Action. Refer to Online Action. |
2 |
Double-click the 140CRP31200 module in the Control Expert rack view. |
3 |
Select the Service Port tab. |
Service Port Parameters
Field |
Parameter |
Value |
Comment |
|
|---|---|---|---|---|
Service Port Mode |
Access (default) |
ETH1 |
You cannot edit the value in the Service Port Number field. |
|
Mirroring |
ETH1 |
|||
Access Port Configuration |
Service Port Number |
ETH1 |
Service Port Mode = Mirroring (see note) |
|
ETH1 |
Service Port Mode = any available source port |
|||
Port Mirroring Configuration |
Source Port(s) |
Internal Port |
Yes |
Ethernet traffic destined for the module |
No |
||||
ETH2 |
Yes |
traffic through the 140CRP31200 INTERLINK port |
||
No |
||||
ETH3 |
Yes |
Ethernet traffic through the first remote I/O port |
||
No |
||||
ETH4 |
Yes |
Ethernet traffic through the second remote I/O port |
||
No |
||||
Description |
— |
— |
— |
description of the source port |
NOTE: In port
mirroring mode, the SERVICE port acts like
a read-only port. That is, you cannot access devices (ping, connection
to Control Expert, etc.) through the SERVICE port.
|
||||
Buttons on the Service Port tab:
Button |
Description |
|---|---|
Update |
After you change Service Port parameters, press this button so that the module can use the new configuration. |
Refresh |
This button reads the latest Service Port configuration from the module. |
On Line Behavior
The Service Port parameters are stored in the application, but you can reconfigure (change) the parameters in connected mode. Values that you reconfigure in connected mode are sent to the 140CRP31200 module through explicit messages. (The changed values are not stored, so a mismatch can exist between the parameters that are being used and those in the stored application.) If the module does not respond to the explicit messages, a message appears.
Limitations
The SERVICE port on the 140CRP31200 module has the same limitations as the cloud port of the dual-ring switch (DRS). Therefore, the cloud port on the module and the cloud port on the DRS can be connected to the same equipment.
For more information about considerations that apply to the use of the distributed I/O cloud port on the DRS, refer to the topic Predefined Configuration Files topic in the Quantum Ethernet I/O System Planning Guide.