Output Characteristics
Original instructions
About us
Output Characteristics Table
The table below describes the output characteristics of the BMX MSP 0200 in the documented wiring configuration.
Characteristics
PTO output
Auxiliary output
Nominal values
Voltage
24 VDC
Current
0.05 A
Limit values
Voltage
19---30V
Current/Point
0.1 A (Disjunction at 0.13 A)
Current/PTO Channel
0.4 A
Leakage current
At state 0
< 50 μA
Residual voltage
At state 1
< 150 mV (with drive interface)
Minimum load impedance
15 kΩ
Maximum capacity
100 nF
Output frequency
  • 200 kHz with cable length < 10 m (32.8 ft) with the RS422 compatible circuits.
  • 100 kHz with cable length < 5 m (16.4 ft) with the normal source input circuit in 24V.
  • 200 kHz with USIC and VW3M8210R05 (0.5 m (1.64 ft)) connected to PTO side.
< 150 μs
Max overload time
50μs
Switching frequency on inductive load
Not applicable (only resistive load allowed)
Output paralleling
Not applicable (dedicated function by output)
Compatibility with DC inputs
With RS422: 7 mA inputs
With SOURCE inputs: 5 V to 24 V
With signal converter (USIC)
Built-in protection
Against overvoltage
No
No
Against reverse polarity
Yes, by reverse-mounted diode.
Yes, by reverse-mounted diode.
Against short circuits and overloads
Yes, by current limiter and electronic circuit-breaker for one PTO channel (4 outputs) 0.13 A < Id (by output) < 1 A
Preactuator voltage Monitoring threshold
OK
> 14 V
> 14 V
On low-voltage condition
< 8 V
< 8 V
Monitoring response time
On disappearance
1.2 ms < T < 1.5 ms
On appearance
1.2 ms < T < 1.5 ms