Physical description of the TSX CCY 1128
(Original Document)
About us
Introduction
The interface connectors of the inputs and outputs towards the machine are distributed on the front face of the module. The connector for connecting to the X bus is found to the back. All the command signals and data of the processor pass through this bus.
View of the module
The diagram below shows the TSX CCY 1128 module and its various elements.
Elements and their functions
Addresses
Elements
Functions
1
Screw
Attaches the module to the TSX RKY •• rack
2
Module casing
Performs the following functions:
• support and protection of the electronic boards,
• locking of the module into its slot,
• Supports connectors.
3
Display block comprising 4 LEDs:
• green RUN LED
• red ERR LED
• red I/O LED
• green CH0 LED
Display the statuses and faults of the module as well as channel diagnostics.
Indicates the operating mode of the module,
Indicates an internal module error,
Indicates an external module error or an application fault,
Provides channel diagnostics.
The various LED-status displays and their meanings
4
SUB-D 15 points connector
Enables connection to the encoder.
5
HE 10 connector
Enables connection of the track outputs of groups 0 and 1
6
HE 10 connector
Enables connection of the track outputs of groups 2 and 3.
7
HE 10 connector
Enables connection of the auxiliary inputs and encoder power supply.