1

Determine which channel and slot location are being used for this module.

2

Wire a field device to the appropriate terminals (refer to the individual wiring diagrams/field connector drawings for that particular I/O module) on either the AS-8534-000 low density connector, or AS-8535-000 high density connector, (refer to the Specification section for your particular I/O module to determine which connector is required.)

3

Stop the controller.

4

Install the I/O module.

5

I/O Map the module, at the desired discrete or register reference.

6

Start the controller.

7

Confirm that the modules active light is illuminated. (may require Step 8 wiring first).

8

To turn an Input on apply the required power to the appropriate terminals (refer to the individual wiring diagrams/field connector drawings for your particular I/O module), and confirm that the red I/O light is illuminated after turning I/O point on.