|
B875–200 Configurable A/D Input, Input Pack Insertion
|
|
|
(Original Document)
|
|
B875–200 Configurable A/D Input, Input Pack Insertion
|
|
|
(Original Document)
|
|
Step
|
Action
|
|---|---|
|
1
|
Remove channel pull-off tabs that correspond with desired input pack placement.
|
|
2
|
Insert input packs into right side of module corresponding to desired channels. Align input pack so that Phillips-head screw is on top and 14 leads are at bottom.
|
|
3
|
Tighten Phillips-head screw.
Note: When using either a AS–5B32001A or AS–5B32002A current input pack, a fusible resistor must also be inserted into the board. The proper fusible resistor (part # AS–0418–000) comes with the current input pack.
Note: Always insert the fusible resistor before inserting the input pack. If the fusible resistor is rectangular, ensure that the side with two leads is next to the input pack.
Note: Never place the fusible resistor between adjacent channels. This can be detected when the fusible resistor hides the CH on the channel label on the board.
|
|
4
|
Locate write-on label plate (part # AS–157A–000) shipped with module. Ensure that input pack catalog numbers and input register numbers for each input pack installed are clearly identified on label.
|
