How to Modify the Output Reset Parameter

At a Glance

This parameter defines the reactivation mode of disconnected outputs.

The modes are as follows.

Mode	Meaning
Programmed	Reactivation is executed with a command from the PLC application or through the appropriate debug screen. Remark: In order to avoid repeated reactivations, the module ensures an automatic 10s delay between two resets.
Automatic	The reactivation is executed automatically every 10s until the error disappears.

Mode

Meaning

Programmed

Reactivation is executed with a command from the PLC application or through the appropriate debug screen.

Remark: In order to avoid repeated reactivations, the module ensures an automatic 10s delay between two resets.

Automatic

The reactivation is executed automatically every 10s until the error disappears.

The reactivation mode is defined for 8-channel groups.

The following table shows the procedure for defining the module output channel reset mode.

Step	Action
1	Open the desired module configuration screen.
2	For the desired channel group, click on the arrow of the Reactivate drop-down menu. Result : The following list appears.
3	Select the required reactivation mode.
4	Validate the modification by clicking Edit > Confirm.