Counting modules physical outputs

General

Each counting module channel offers one to four physical outputs Q0 to Q3, according to the module.

Q0 and Q1 outputs, available in all modules, can be configured using two modes:

manual mode: the state of the output is monitored by the software as for a discrete output,
automatic mode: the output copies the associated switch state (switch 0 or 1), and therefore the latches defined for these switches.

This mode is used to set up reflex actions in the module.

Q2 and Q3 outputs (only available in TSX CTY 2C modules), have more limited configuration options (see: Introduction to TSX CTY2C module outputs.

The behavior of outputs in the event of a fault (ie. in fallback mode) varies according to whether the module is a TSX CTY 2A / 4A or a TSX CTY 2C.

In the event of a trip (ie. through a voltage surge or short-circuit), outputs must be reset manually using the application, or automatically when the voltage surge disappears.