Installing the module
(Original Document)
About us
General
The mounting and removal of a module can be done with the power on.
Inserting/extracting module with the power on must be done by doing/undoing the screws manually in order to maintain an adequate sequencing of the connection/disconnection of the signals on the X bus. Using an electric screwdriver cannot assure this sequencing.
Procedure
Step
Action
Illustration
1
Place the pins situated on the back of the module in the centering holes situated on the lower part of the rack.
2
Pivot the module in order to bring it into connect with the rack.
3
Fix the module to the rack by tightening the screw situated on the upper part of the module
4
You must not insert or take out the communication card while the reception module is powered up.
Insert the card into its slot
5
Screw the card in so that it cannot move, thus ensuring it will operate properly.
6
You must not connect or disconnect the connection unit while the module is powered up.
Connect the cable to the connection unit
7
Screw the connector in so that it cannot move, thus ensuring a good connection.