Module Configuration Screen
Original instructions
About us
Configuring an Ethernet Network
Use the two-zone Ethernet network configuration screen to declare the communication channel and to configure the necessary parameters for an Ethernet link.
Elements and Functions
This table describes the various zones that make up the configuration screen:
Zone
Area
Function
common
Header
Common part of the Ethernet communication configuration screens. This part enables you to choose the network family to be configured. When the network is associated with a module, the module address appears in the Module address zone.
specific
Module Services
Allows selection of the services used by the module
IP Module Address
Displays the module address
Security tab
Allows enabling and disabling of FTP, TFTP, and HTTP.
IP Configuration tab
Enables the configuration of TCP/IP services
Messaging tab
Allows the configuration of Access Control for the module.
IO Scanning tab
Allows configuration of I/O Scanning
Global Data tab
Allows configuration of Global Data
SNMP tab
Allows configuration of SNMP
Address Server tab
Allows configuration of the address server
Bandwidth tab
Allows you to check that the services configured are compatible with the processing capacity of the Ethernet channel
NTP tab
Allows configuration of Time Service
Mail Service web page
Allows configuration of Mail Service
NOTE: In the Control Expert software, the TSX WMY 100 module is set in the TCP/IP Regular Network family, although it belongs to the TCP/IP FactoryCast network family. So, the services listed above (I/O scanning, Global Data, address server, Bandwidth monitoring) are not supported by the module. However, they can be selected in the TCP/IP regular network configuration in Control Expert. (Even if they are configured, those services won't work with the module.)