This quick start guide explains how to install and configure Modicon Premium Ethernet modules, set up and configure an I/O scanning communication service, and access the modules diagnostic capabilities. The following modules are applicable to this guide:
-
TSX ETY 4103
-
TSX ETY 5103
-
TSX P57 1634M
-
TSX P57 2634M
-
TSX P57 3634M
-
TSX P57 4634M
-
TSX P57 5634M
NOTE: When starting up a TSX P57 6634/5634/4634 processor, the CPU may send an address resolution protocol (ARP) request to verify the existence of a device using the IP address 192.168.2.1. The source IP address of this packet is the broadcast address of the CPU (the last IP address used in the PLC application, ending in 255).
Hardware/Software Requirements
For the example discussed in this guide, the following Modicon Premium Ethernet modules are required:
Also, a PC running Windows 2000 or XP with Schneider’s Control Expert configuration software installed on it is required.
Finally, a USB cable is required to connect the PC to the network PLC.
This user guide is intended for anyone who is involved in installing and configuring Modicon Premium Ethernet modules in a network arrangement that performs basic communication services.
Anyone reading this guide should:
