Characteristics of the TSX ASY 410 Module
(Original Document)
About us
Introduction
This part presents general characteristics for the TSX AEY 410 module and characteristics of its analog outputs.
General Characteristics
This table presents the general characteristics for the TSX AEY 410 module:
Type of outputs
Isolated inputs between channels
Nature of outputs
Voltage / Current
Number of channels
4
Output refresh time
2.5 ms
Power supply for outputs
by the PLC
Types of protection
Short circuits and overloads
Insulation:
  • between channels
  • between channels and bus
  • between channels and ground
1500 V rms
1500 V rms
500 VDC
Isolation resistance under 500VDC between channel and ground
> 10 mOhms
Diaphony between channels
-80 dB
Monotonicity
Yes
Non linearity
<= 1 LSB
RC network ground connection
R = 50 MOhms, C = 4.7 nF
Dissipated power:
  • typical
  • maximum
8.2 W
12.2 W
Voltage Outputs
This table presents the general characteristics for the TSX AEY 410 module voltage outputs:
Variation range
+/- 10 V
Full scale (FS)
10 V
Max voltage without damaging the voltage outputs
+/- 30 V
Load impedance
1 KOhm minimum
Capacitative load
< 100 nF
Maximum resolution:
  • software version Sv or VL > 1.0
  • software version Sv or VL = 1.0
5.12 mV to +/- 10 V
4.88 mV to +/- 10 V
Measuring error:
  • at 25°C
  • from 0 to 60°C
0.45 % of FS
0.75 % of FS (35 ppm/°C)
Current Outputs
This table presents the general characteristics for the TSX AEY 410 module current outputs:
Variation range
20 mA
Full scale (FS)
20 mA
Max voltage without damaging the voltage outputs
+/- 30 V
Load impedance
600 Ohms maximum
Inductance load
< 0.3 mH
Maximum resolution:
  • software version Sv or VL > 1.0
  • software version Sv or VL = 1.0
0.01025 mA
0.00977 mA
Measuring error:
  • at 25°C
  • from 0 to 60°C
0.52 % of FS
0.98 % of FS (70 ppm/°C)
Maximum leakage current
0.05 mA