Characteristics of the BMXCPS3500 Power Supply Module
Original instructions
About us
Introduction
The BMXCPS3500 module is alternating current power supply module.
Altitude Operating Conditions
The characteristics in the table below apply to the BMXCPS3500 and BMXCPS3500H power supply modules for use at altitude up to 2000 m (6560 ft). When the power supply modules operate above 2000 m (6560 ft), apply additional derating.
For detailed information, refer to chapter Operating and Storage Conditions.
Characteristics
Characteristics of the primary block
Nominal voltage
100 - 120 Vac/200 - 240 Vac
Voltage range
85 - 264 Vac
Nominal frequency / frequency range
50-60 Hz/47-63 Hz
Power
120 VA
Nominal current consumption
1.04 A at 115 Vac
0.52 A at 240 Vac
Initial power-up at 25 °C(1)
InRush current I
≤ 30 A at 120 Vac
≤ 60 A at 240 Vac
I2t
at locking
≤ 1 A2s at 120 Vac
≤ 3 A2s at 240 Vac
It
at locking
≤ 0.05 As at 120 Vac
≤ 0.07 As at 240 Vac
Acceptable duration of power interruptions
≤ 10 ms
Built-in over-current protection
By internal, inaccessible fuse
Characteristics of the secondary block
Total useful power
36 W
Maximum useful power at the two outputs, 3V3_BAC and 24V_BAC
31.2 W
3V3_BAC output
Nominal voltage
3.3 Vdc
Nominal current
4.5 A
Power (typical)
15 W
24V_BAC output
Nominal voltage
24 Vdc
Nominal current
1.3 A
Power (typical)
31.2 W
24V_SENSORS output
Nominal voltage
24 Vdc
Nominal current
0.9 A
Power (typical)
21.6 W
3V3_BAC, 24V_BAC and 24V_SENSORS output protection
Against overload, short circuits and over-voltage
Maximum Dissipated Power
8.5 W
Characteristics of the auxiliary functions
Alarm relay
Normally open dry contacts
Display
Front panel LED
Back-up battery
No
Isolation
Dielectric resistance
at 50 Hz-1mn
Primary/secondary (24V_BAC/3V3_BAC)
1,500 Vrms
Primary/secondary (24V_SENSORS)
2,300 Vrms
Primary/ground
1,500 Vrms
24V_SENSORS/ground output
500 Vrms
Insulation resistance
Primary/secondary
≥ 100 MΩ
Primary/ground
≥ 100 MΩ
Operating temperature
BMXCPS3500
0...60 °C (32...140 °F)
BMXCPS3500H
-25...70 °C (-13...158 °F)
(1) These values are to be taken into account for the start-up of several devices simultaneously or for establishing the size of the protection devices.