When selected, enables SNMP for the module and lets you configure attributes of the SNMP category.

For certain devices, the check box is selected and read-only.

Your configuration is retained when you select/clear the check box.

Version of SNMP that is used for communication.

Possible values:

• V1

• V3

  . For CPU modules, the value is available only for firmware versions 4.00 and later.

The possible values depend on the type and version of device.

Your configuration is retained when you switch SNMP versions.

IP addresses of the first and second SNMP managers to which the agent that runs in the device sends trap notifications.

IP Address Manager 2

Required.

To be valid, the user name must satisfy the following rules:

• 32 characters maximum.

• Contains only any combination of ASCII characters from 33 to 122.

• Spaces are not allowed.

When selected (true), the Location (SysLocation) and Contact (SysContact) attributes are hidden and managed by the SNMP manager.

Enter the physical location of the device by using characters of the US-ASCII table (32 characters maximum).

Enter the contact information of the person in charge of device maintenance by using characters of the US-ASCII table (32 characters maximum).

Password that the agent requires before it executes write commands received from the SNMP manager.

Password that the agent requires before it executes read commands received from the SNMP manager.

Password that the SNMP manager requires before it accepts trap notifications from an agent.

When selected (true), the agent sends a trap notification to the SNMP manager in case it receives a Get or Set request from a device that it cannot authenticate.