Service Diagnostics
Original instructions
About us
Introduction
View this information when you access the DIAGNOSTICS web page.
SNTP
This table describes the SNTP parameters:
Parameter
Description
SERVICE STATUS
Running: The correctly configured service is running.
Disabled: The service is disabled.
Unknown: The status of the service is not known.
SERVER TYPE
Primary: A primary server polls a master time server for the current time.
Secondary: A secondary server polls a master time server for the current time.
CURRENT DATE
This field shows the current date in the selected time zone.
SERVER STATUS
  • green: The server is connected and running.
  • red: An error is detected.
  • gray: The server status is not known.
DST STATUS
On: DST (daylight saving time) is configured and running.
Off: DST is disabled.
Unknown: The DST status is not known.
CURRENT TIME
This field shows the time of day.
TIME ZONE
This field shows the time zone.
Clock
This table describes the clock parameters:
Parameter
Description
CURRENT DATE AND TIME
Date (module date)
Time (module time)
TIME ZONE
(module time zone)
LATEST TIME SYNCHRONIZATION
Date (synchronization timestamp)
Time (synchronization timestamp)
Time Source (synchronization timestamp):
  • — (none): If the RTU protocol is not configured, the RTU clock runs free and gets its time from 1970/1/1.
  • CPU Module: If the RTU protocol is configured, the RTU can get its initial time from the CPU when the RTU protocol starts or restarts.
  • Controlling Station: field shows the time source when a SCADA system or a master synchronizes its time with the RTU.
  • NTP Server: If the SNTP client is enabled and connected to the SNTP server, its time source is from an SNTP server that synchronizes to the BMENOR2200H module's internal clock.