Each module or device in the Control Expert Hardware Catalog is represented by a device type manager () that defines its parameters.
Any configuration done through the DTM is performed within the Control Expert environment.
In general terms, the device DTM is automatically installed when you install Control Expert.
In any other case, you can install the DTM on a host PC (the PC that runs Control Expert) to make the device DTM available for use in Control Expert.
For third-party modules, the DTM installation process is defined by the manufacturer. Consult those instructions to install a DTM on your PC.
After a device DTM is successfully installed on your PC, update the Control Expert Hardware Catalog to see the new DTM in the catalog. The DTM is then added to your Control Expert configuration when the corresponding module is added to the project.
