How to Return to Gross Weight Measurement via the Program
(Original Document)
About us
Introduction
This function cancels the tare value so that the current weight value is in gross weight.
The current weight is stored in the word %Idr.m..0.0, in the format set in configuration.
Execution Conditions for the Tare Mode
This command does not require any particular execution conditions.
Procedure
The following table describes the procedure for executing a return to measurement in gross weight.
Step
Action
Behavior of the Module
1
Input the WRITE_CMD while programming the tare mode order (%MWr.m.0.3.6 = 1).
-
2
Confirm the execution, with the application in RUN.
The module switches to "return to gross weight" mode.
The module then sets the tare to zero.
The NET = 0 (%Iwr.m..0.4.8=0) flag shows the end of the procedure.
3
Check that the command has been performed correctly: State of the NET flag: %IWr.m.0.4.8
-
Summary of the Data Used
The following table provides the data used for resetting to zero.
Type
Role
Associated Data
Command
Return to gross weight order
%MWr.m.0.3.6
Display
Measured weight
%IDr.m.0.0
Value of the Tare in progress
Premium/Atrium: %IDr.m.0.5
M580: %IDr.m.0.6
Exchange
Processing in progress
%IWr.m.0.4.5
Gross weight
%IWr.m.0.4.8 = 0