Introduction to the TBX DMS 1025 module
(Original Document)
General
The TBX DMS 1025 is a modular base unit comprising 8  24 V DC inputs, compatible with 2 and 3 wire proximity sensors and 2 50 VA relay outputs. The module is equipped with a terminal block for direct wiring of the sensors and preactuators, which can be removed when it is switched off.
The sensor voltage is monitored to ensure that there is sufficient voltage for the inputs to operate correctly.
The inputs of this module have functions which, in certain cases, are common to a group of channels. Thus, it is possible to assign the 2 channel groups of the module to the various tasks in the application.
Technical specifications
The following table provides the technical specifications of the module.
TBX DMS 1025
Nominal voltage
24 V DC
Supply voltage +SV
19,2 V DC to 30 V DC
Current drawn on +SV of the base module (at 24 V)
if basic unit
35 mA typically
if extension base unit
25 mA typically
Current drawn at +SV by extension module (at 24 V)
10 mA typically
Current drawn at +IS (at 24 V)
(loading = 60 %)
75 mA typically
Power dissipated at nominal load in the module
(loading = 60 %)
2,6 W at 24 V
Dielectric strength between inputs and ground (GND)
1500 V rms - 50/60 Hz for 1 min
Isolation resistance
> 10 MΩ below 500 V DC
Key:
SV
Power supply to module (communication module if present and input/output interfaces).
IS
Power supply to sensors.