Advanced Settings Tab

Introduction

The Advanced Settings tab is only available for CPUs that do not support RIO scanning (DIO scanner service only). The Advanced Settings contains these fields:

EtherNet/IP Timeout Settings
EtherNet/IP Scanner Behavior

Timeout Settings

These parameters are in the EtherNet/IP Timeout Settings field:

Parameter	Value	Comment
FW_Open I/O Connection Timeout (msec)	4960	Specifies the amount of time the scanner waits for FW_Open response of an I/O connection.
FW_Open EM Connection Timeout (msec)	3000	Specifies the amount of time the scanner waits for FW_Open response of an EM connection.
EM Connection RPI (msec)	10000	Sets T->O and O->T RPI for all EM connections.
EM Request Timeout (sec)	10	Specifies the amount of time the scanner will wait between the request and the response of an explicit message.

Scanner Behavior

These parameters are in the EtherNet/IP Scanner Behavior field:

Parameter	Value	Comment
Allow RESET via explicit message	Disabled	(Default.) The scanner ignores the Identity object reset service request.
Allow RESET via explicit message	Enabled	The scanner will reset if an Identity object reset service request is received.
Behavior when CPU state is STOP	Idle	(Default.) The EtherNet/IP I/O connection stays open, but the Run/Idle flag is set to Idle.
Behavior when CPU state is STOP	STOP	The EtherNet/IP IO connection is closed.