How to access the SET and RESET commands
(Original Document)
About us
At a Glance
These commands are used to change the state of a module's outputs to  0 (RESET) or 1 (SET).
NOTE: the state of the output affected by one of these commands is temporary and can be modified at any time by the application when the PLC is in RUN.
Procedure
The table below shows the procedure for assigning the value  0 or 1 to all or part of the channels of a module.
Step
Action for one channel
1
Access the module's debug screen.
2
In the Value column, right-click the cell of the required channel.
3
Select the desired function.
  • Set,
  • Reset.