How to modify the Output Reactivation Parameter of a Discrete Module

At a Glance

This parameter defines the reactivation mode of disconnected outputs.

Possible modes are:

Mode	Meaning
Programmed	Reactivation is executed with a command from the PLC application or through the appropriate debug screen. Note: In order to avoid repeated reactivations, the module ensures automatically a 10 s delay between two reactivations.
Automatic	The reactivation is executed automatically every 10 s until the error disappears.

The reactivation mode is defined for 8 channel groups.

NOTE: The modification of this parameter is possible in online mode.

Procedure

The following table shows the procedure for defining the module output channel reactivation mode.

Step	Action
1	Open the desired module configuration screen.
2	For the desired channel group, click on the arrow of the Reactivate drop-down menu of the General parameters zone. Result: A drop-down list appears.
3	Choose the desired reactivation.
4	Confirm the modification with the Edit → Validate menu command.