Altitude Operating Conditions
The characteristics in the table below apply to the modules BMX DAO 1605 and BMX DAO 1605H for use at altitude up to 2000 m (6560 ft). When the modules operate above 2000 m (6560 ft), apply additional derating.
For detailed information, refer to chapter Operating and Storage Conditions.
General Characteristics
This table presents the general characteristics for the BMX DAO 1605 and BMX DAO 1605H modules:
Module type |
100...240 VAC triac outputs |
||
Operating temperature |
BMX DAO 1605 |
0...60 ºC (32...140 ºF) |
|
BMX DAO 1605H |
-25...70 ºC (-13...158 ºF) |
||
Temperature derating |
Apply the temperature derating curve |
||
Nominal values |
Voltage |
100...240 VAC |
|
Current |
0.6 A / points |
||
Threshold values |
Voltage |
100 mA at 24 VAC 25 mA at 100...240 VAC |
|
Current/channel |
0.6 A |
||
Current/module |
2.4 A max/common (4.8 A max for all commons) |
||
Maximum inrush current |
20 A / cycle or less |
||
Leakage current |
At state 0 |
≤ 3 mA (for 240 VAC, 60 Hz) ≤ 1.5 mA (for 120 VAC, 60 Hz) |
|
Residual voltage |
At state 1 |
≤ 1.5 VAC |
|
Response time |
≤ 1 ms + 1/(2xF) |
||
Built-in protection |
Against inductive over voltage in AC modes |
None. Fit an RC circuit or a ZNO type over voltage limiter in parallel on each output appropriate to the voltage in use |
|
Against inductive over voltage |
None. Fit a discharge diode on each output. |
||
against short-circuits and overloads |
None. Fit a fast-blow fuse of 3 A on each channel or 4-channel group. |
||
Command type |
Zero crossing |
||
Output protection |
no protection |
||
Dielectric maximum voltage |
2 830 VAC rms/1 min |
||
Insulation resistance |
≥ 10 MΩ (by insulation resistance meter) |
||
Noise immunity |
By noise simulator of noise voltage, 1 μs noise width and 1 500 Vp-p 25...60 Hz noise frequency |
||
Power consumption 3.3 V |
Typical |
79 mA |
|
Maximum |
111 mA |
||