Characteristics

Altitude Operating Conditions

The characteristics in the table below apply to the modules BMX DRA 1605 and BMX DRA 1605H for use at altitude up to 2000 m (6560 ft). When the modules operate above 2000 m (6560 ft), apply additional derating.

For detailed information, refer to chapter Operating and Storage Conditions.

General Characteristics

This table presents the general characteristics for the BMX DRA 1605 and BMX DRA 1605H modules:

Module type			Relay outputs for alternating and direct current
Operating temperature	BMX DRA 1605		0...60 ºC (32...140 ºF)
	BMX DRA 1605H		-25...70 ºC (-13...158 ºF)
Rated voltage	Direct		24 VDC
	Alternating		24...240 VAC / 2 A, Cos ? = 1
Voltage range	Direct		24 VDC / 2 A (resistive load)
	Alternating		19...264 VAC / 2 A, Cos ? = 1
Minimum switching load			5 VDC / 1 mA.
Maximum switching load			264 VAC / 125 VDC
Mechanical service life	Number of switching		20 million or more
Alternating current load in resistive mode (AC12)	Voltage		24 VAC	48 VAC	100...120 VAC	200...240 VAC
	Power		50 VA⁽²⁾	50 VA⁽¹⁾ 80 VA⁽²⁾	80 VA⁽¹⁾ 200 VA⁽²⁾	200 VA⁽¹⁾
Alternating current load in inductive mode (AC15)	Voltage		24 VAC	48 VAC	100...120 VAC	200...240 VAC
	Power		36 VA⁽¹⁾ 72 VA⁽¹⁾ 120 VA⁽²⁾	36 VA⁽¹⁾ 72 VA(1) 120 VA⁽²⁾	36 VA⁽¹⁾ 72 VA⁽¹⁾ 120 VA⁽²⁾	36 VA⁽¹⁾ Cos ? = 0,35 72 VA⁽¹⁾ Cos ? = 0,7 120 VA⁽²⁾ Cos ? = 0,35 240 VA⁽²⁾ Cos ? = 0,7
Direct current load in resistive mode (DC12)	Voltage		24 VDC		48 VDC
	Power		24 W⁽²⁾		24 W⁽⁴⁾
Direct current load in inductive mode (DC13)	Voltage		24 VDC		48 VDC
	Power (L/R = 7 ms)		3 W⁽¹⁾ 10 W⁽²⁾		3 W⁽¹⁾ 10 W⁽²⁾
	Power (L/R = 20 ms)		24 W⁽³⁾		24 W⁽³⁾
Response time	Activation		< 8 ms
	Deactivation		< 10 ms
On-line module change			Possible
Built-in protection	Against alternating current inductive over voltage		None. Fit an RC circuit or a ZNO type over voltage limiter in parallel on each output appropriate to the voltage in use.
	Against direct current inductive over voltage		None. Fit a discharge diode on each output.
	Against short-circuits and overloads		None. Fit a fast-blow fuse of 12 A for each 8-channel group.
Maximum switching frequency			3 600 cycles per hour
Power dissipation			3 W max
Dielectric strength (at 50/60 Hz for 1 min.)			2000 V actual
Resistance of insulation (at 500 VDC)			> 10 MΩ
Noise immunity			In noise simulation below 1500 V actual, noise width of 1s and frequency of 25 to 60 Hz
Reliability	MTBF for continuous operation in hours at ambient temperature 30°C (86°F)		1 357 810
Power supply consumption	3.3 V	Typical	79 mA
		Maximum	111 mA
	24 V relay⁽⁵⁾	Typical	89 mA
		Maximum	100 mA
(1): 3 x 10⁵ cycles, (2): 1 x 10⁵ cycles, (3): 7 x 10³ cycles, (4): 5 x 10⁴ cycles, (5): per channel at 1.

NOTE: For the BMX DRA 1605H module, the maximum power must not exceed 24 VA per channel when operated at 70 °C (158 °F).