How to Connect BMX EHC 0200 Module: Connecting 16-Pin and 10-Pin Terminal Blocks
Original instructions
About us
At a Glance
The BMX EHC 0200 counting module uses the following terminal blocks:
Description of the 10 and 16 Pin Terminal Blocks
The following table shows the characteristics of the BMX EHC 0200 terminal blocks:
Characteristic
Available
Type of terminal block
Spring terminal blocks
Number of wires accommodated
1
Wire gauge accommodated
Minimum
AWG 20 (0.5 mm2)
Maximum
AWG 18 (1 mm2)
Wiring constraints
To insert and remove wires from the connectors, use a flat-tipped screwdriver with a 2.5 mm wide and 0.4 mm thick blade. With the screwdriver, push the flexible plate down on the outside (the side closest to the corresponding receptacle) to open the round receptacle.
A screwing (rotating) or bending motion is not required.
DANGER
HAZARD OF ELECTRIC SHOCK
Turn off all power to sensor and pre-actuator devices before connection or disconnection of the terminal block.
Failure to follow these instructions will result in death or serious injury.