Installation of Module

Prerequisites

The set up and removal of a module can be done after power-up.

Insertion / extraction when the module is powered up, can be done through manual screwing / unscrewing to maintain an adequate connection / disconnection sequencing of X-Bus signals.

Using an electric screwdriver does not maintain this sequencing.

Procedure

The following procedure shows how a TSX IBY 100 module is set up on a rack.

Step	Action	Illustration
1	Place the pins on the back of the module in the centering holes on the lower part of the rack.
2	Rotate the module to connect it with the rack.
3	Fix the module to the rack by tightening the screw on the upper part of the module.