Language Objects Associated with Configuration of the TBX SAP 10 Module
(Original Document)
About us
At a Glance
This page describes all the configuration language objects associated with the TBX SAP 10 module. These objects are initialized from the configuration screen. They are transmitted to the module when a new configuration is received or upon warm or cold restart. They can be displayed by the application program.
Syntax
These configuration objects have the following syntax:
Configuration Objects
The following table describes the configuration objects:
Object
Function
Meaning
%KW\2.e\0.0.0.0
AS-i master
Octet 0 = 10 AS-i identification in the application-specific communication function.
%KW\2.e\0.0.0.1
LPS
Projected slave list.
bit n = 1 if slave n in the list.
%KW\2.e\0.0.0.2
LPS
Projected slave list.
bit n = 1 if slave n in the list.
%KW\2.e\0.0.0.3 to
%KW\2.e\0.0.0.18
I/O configuration
I/O and identification code (ID)
Byte 0 = slave 0.
bit 0 to 3: I/O configuration and bit 4 to 7: Identification.
Byte 1 = slave 1.
bit 0 to 3: I/O configuration and bit 4 to 7: identification
%KW\2.e\0.0.0.20 to
%KW\2.e\0.0.0.51
Information on the catalog
Identification of the slave 0 to 31.
NOTE: LPS is the list of projected slaves. In compliance with the AS-i standard, this is the list of slaves that must be acknowledged when a configuration is received. In this case, the AS-i bus is in AS-i protected mode. AS-i protected mode corresponds to the mode configured in Control Expert.