Configuring the General Parameters for I/O Scanning

Introduction

For configuring I/O scanning, the read and write zones are general at the remote inputs/outputs:

Master %MW Zones

This sub-window is used to define the ranges of internal words of the application memory (%MW) specific to the read and write zones.

To do this, you must complete:

for the read zone, Read Ref. (the starting address in the table of internal words for reading inputs)
for the write zone Write Ref. (the starting address in the table of internal words for writing outputs)

The length of tables has a maximum exchange capacity of:

NOTE: The tables must not overlap and an overrun check is made on global validation.