The AS-i cable test mode, which is particularly useful when starting up new installations, allows the display on the front of the TSX SAY 100 module:
-
the slaves provided and detected,
-
the slaves not provided and not detected,
-
the slaves provided and not detected, or not provided and detected.
For each slave present on the bus, this mode also allows display of the status of the input/output bits.
NOTE: Lists of LDS and LAS and the adjustment parameters of the slaves are not accessible in this mode.
The AS-i cable test mode is an AS-i function that is accessible when:
-
the TSX SAY 100 module is in non configured mode.
This mode is obtained when:
-
each device has a separate address.
-
address 0 is not used.
