Modifying the Output Power Supply and Power Supply Fault Control parameters for the TSX ASY 800 module
(Original Document)
About us
At a Glance
The Output Power Supply parameter allows you to select the type of supply – internal or external to the module – powering the outputs for the TSX ASY 800 module.
WARNING
UNEXPECTED SYSTEM BEHAVIOR
Do not power more than 2 TSX ASY 800 modules with the power supply from the same rack.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
When the Power Supply Fault Control parameter is enabled, the module checks to verify that there is indeed a 24V power supply, be they internal or external.
NOTE: These two parameters apply to the whole module.
Instructions
The following table provides specific instructions for selecting a type of power supply for the module's channels.
Step
Action
1
Access the hardware configuration screen for the appropriate module.
2
Check the Internal or External box in the Supply field of the General Parameters area.
Results : The type of power supply selected shall be assigned to the module's channels.
3
Validate the change with Edit → Validate.
Instructions
The following table provides specific instructions for selecting a type of Power Supply Fault Control for the module's channels.
Step
Action
1
Access the hardware configuration screen for the appropriate module.
2
Check the 24V output supply monitoring in the General parameters area.
Results : Power Supply Fault Control is enabled.
3
Validate the change with Edit → Validate.