When dynamic routing is used and the Interface attribute of a port is enabled, the IP address of the port (attributes of Interface) must be the gateway address of the logical network.

(The rule does not apply to BMENOC0321 communication modules in redundant PACs).

For a device or module, the Logical Network attribute of each interface that is associated to a port (for example, ETH1_Interface ) must be unique and/or different from that of the Embedded Interface.

Typically, this applies when interfaces are created by enabling the Interface attribute of a port (for example, BKP) but other settings can also create port-specific interfaces.

The host address of a router must not belong to a logical network that any other of its ports belong to (except for BMENOC0321 communication modules).

When several BMENOC0321 communication modules are installed on the rack of a standalone PAC, only one of them can have the Interface attribute of its backplane port enabled.

In a redundant PAC, a BMENOC03•1 communication module in local rack A must not have either of its dual ports linked to the BMENOC03•1 communication module in local rack B when their backplane port is enabled.

For a given logical network, only one device can have a port that is configured with the gateway address of this network (IP address of the Interface attribute of the port).

Within a system project, the Port value that is configured for the simulator must be unique.

For BMENOC03•1 communication modules, the backplane port cannot be enabled if the IPsec service is enabled.