Adding an STB NIP 2212 Remote Device
Original instructions
About us
Overview
Use the generic Modbus DTM selection, in the Add dialog, to select and insert an STB NIP 2212 module to your project.
Adding an STB NIP 2212 Remote Device
To add the STB NIP 2212 to your project, follow these steps:
Step
Action
1
In the DTM Browser, select the Ethernet communication module node, and then click the right mouse button. A pop-up menu opens.
2
In the menu, select Add... The following dialog opens:
3
In the Add dialog, select the STBNIP2212, then click Add DTM. The Properties window for the STB NIP 2212 network interface module opens.
4
In the General page of the Properties window, edit the default Alias name to read NIP2212_01:
When you edit the Alias name, Control Expert applies it as the base name for both structure and variable names.
NOTE: No additional editing needs to be performed in the pages of this window. Except for the Alias name field, parameters are read-only.
5
Click OK. Control Expert adds the new STB NIP 2212 network interface module to the DTM Browser, beneath the communication module.
6
Refer to the topic Configuring Properties in the Device Editor for instructions on how to save your configuration edits.
The next step is to configure the device you have just added to the project.