Introduction
The BMENOR2200H module provides cyber security Syslog when the Advanced mode is enabled.
Configure the syslog client in the module. The logs are stored locally in the module and exchanged with a remote Syslog server.
Access the Page
Access the Event Logs web page through the SETUP tab for the BMENOR2200H module ().
Parameters
Find these parameters and
settings on the on the Event Logs web page:
Parameter |
Description |
|---|---|
Service activation |
Click these buttons to turn the Syslog client services on and off.
NOTE: This service
is on by default. Enter a valid IP address the first time the
module runs in advanced mode to turn the Event Logs service off. Otherwise, the module remains in "invalid configuration" mode.
|
Syslog server IP address |
This
field contains the IPv4 address of the remote Syslog server.
NOTE: If you configure the Syslog server, all events are
forwarded to this IP address.
|
Syslog server port |
This field shows the port number that is used by the Syslog client service. |
Submit |
Click this button to apply the new settings. |
NOTE: Refer to the instructions for setting up a cyber security
audit for event logging in the Modicon Controllers Platform Cyber Security,
Reference Manual.
Execute Changes
After you configure any
of these parameters, press the Apply button
in the page banner to implement your changes.
NOTE: The Apply and Discard buttons are
disabled (grayed out) when the configuration is not valid.