The embedded switch in the BMENOP0300 module includes four Ethernet ports. Use the
Communication Settings → Switch tab to specify the data rate and duplex setting for each port, or you let each port auto-negotiate these settings with the connected device.
Configuring Baud Rate Settings
Select the Enable check box next to the respective port, and choose the desired setting in the Baud Rate drop-down list:
|
Port
|
Available settings
|
|
ETH1
ETH2
ETH3
|
Select one of the following settings:
-
100 Mbits/sec Full duplex
-
100 Mbits/sec Half duplex
-
10 Mbits/sec Full duplex
-
10 Mbits/sec Half duplex
-
Auto 10/100 Mbits/sec (default)
|
|
Backplane
|
100 Mbits/sec Full duplex
|
After you finish editing baud rate settings, click Apply to save your edits.
